Crankcase : precisions die cast, large cooling fins, and anodized for maximum heat dissipation. Sight glass, fill and side and bottom drain plugs. Bearings : Oversized for maximum life and load disbursement, needle bearing on the drive side and ball on the non drive side.
Each bearing is held in postion on the crankshaft and crankcase by snap rings. Valves, Seats and Springs : Stainless steel with specially designed Ultra form material valve cages that impervious to water absorption and provide long life and positive seating. Seal and V-packings : Continuously lubricating for extended life. Plunger Rods : are high strength stainless steel. Connecting Rods : One piece special alloy aluminum based, oversized for maxium strength, load disbursement, and long life. Direct Drive with Gas Flange. Maximum Volume: 3.0 GPM. Maximum Discharge Pressure: 3000 PSI. Maximum Pump Speed: 3400 RPM. Minimum Horsepower Requirement: 9.3 hp for gas engines. Shaft Diameter: 1 ID with gas flange. Change oil after 50 hour break-in period, then in 500 hour intervals thereafter.